Taxi after landing
4 years 1 month ago #16673
by KC135
Taxi after landing was created by KC135
Any one else have this problem, good landing and try to taxi to gate and steering is very erratic. I thought it was a problem with my hardware, but X-Plane works great. I read on line where this a reported issue. For this airline we don't have to taxi to the gate to get credit,
Please Log in to join the conversation.
4 years 1 month ago #16674
by SPA118
Replied by SPA118 on topic Taxi after landing
Haven't had that problem Ron. Using my new X52 Professional H.O.T.A.S. setup here.
www.logitechg.com/en-us/products/space/x...ller.945-000022.html
www.logitechg.com/en-us/products/space/x...ller.945-000022.html
Please Log in to join the conversation.
4 years 1 month ago #16675
by jer029
Replied by jer029 on topic Taxi after landing
I did have that early on, and I thought it usually followed an unusually hard landing so that it might be some type of damage-related setting that shouldn't be triggered because I had that set to off, but who knows. I'm not sure if I ever figured it out, and I'd have to look into the MSFS forums to see if there's information on it. All I know is that I had experienced it with the A320 early on, but not recently.
Please Log in to join the conversation.
4 years 1 month ago #16676
by KC135
Replied by KC135 on topic Taxi after landing
I read some users had this problem too, so don't know. This latest landing was not a hard landing. I did notice in the pilot assist settings that the yaw damper was on, but it should be on during flight, but not on the ground.
Please Log in to join the conversation.
4 years 1 month ago #16677
by SPA031
Replied by SPA031 on topic Taxi after landing
I like my X52 H.O.T.A.S.. One can download their customization software for it.
The FS2020 control device setup allows you to adjust the dead zones and sensitivity for the X52. You need to adjust these parameters.
It would be nice if I had rudder pedals and a yoke someday. And, maybe a VR headset too.
The FS2020 control device setup allows you to adjust the dead zones and sensitivity for the X52. You need to adjust these parameters.
It would be nice if I had rudder pedals and a yoke someday. And, maybe a VR headset too.
Please Log in to join the conversation.
4 years 1 month ago #16678
by KC135
Replied by KC135 on topic Taxi after landing
No problem with my controls. All good with X-Plane. With FS2020 the only problem is after landing and taxi to gate. I will check yaw damper for change. The y/d should only used while airborne.
Please Log in to join the conversation.
Time to create page: 0.069 seconds