P3d-v4 and available aircraft
6 years 4 months ago #14796
by jer029
P3d-v4 and available aircraft was created by jer029
Just a note to P3d-v4 pilots, don't fret about having to pay for all your favorite FSX planes all over again, only a few of the higher-end payware models are being offered at additional cost for upgrade to P3d-v4. I'm told PMDG is one of the most expensive upgrades and perhaps A2A. Also, Majestic requires about half the original price for the p3dv4 upgrade.
While this is unfortunate, we can be thankful for the many things that seem to transfer without issue (even if not recommended by LM).
I've found that the following can be put right into p3d without modification:
Aerosoft Beaver
Qwest Kodiak
Realair Lancair Legacy
Additionally, many of the Carenado and Aerosoft models have been updated for p3dv4 and have free upgrades if you have the purchased fsx versions.
I'm not sure about the freeware stuff, but I'm guessing the developers of those will be offering upgrades for many of those as well if they haven't already.
On the scenery end, all of the Orbx/FTX stuff I think can be upgraded to p3dv4 for no additional cost.
John<br /><br /><!-- editby --><br /><br /><em>edited by: jer029, Sep 10, 2018 - 04:29 PM</em><!-- end editby -->
While this is unfortunate, we can be thankful for the many things that seem to transfer without issue (even if not recommended by LM).
I've found that the following can be put right into p3d without modification:
Aerosoft Beaver
Qwest Kodiak
Realair Lancair Legacy
Additionally, many of the Carenado and Aerosoft models have been updated for p3dv4 and have free upgrades if you have the purchased fsx versions.
I'm not sure about the freeware stuff, but I'm guessing the developers of those will be offering upgrades for many of those as well if they haven't already.
On the scenery end, all of the Orbx/FTX stuff I think can be upgraded to p3dv4 for no additional cost.
John<br /><br /><!-- editby --><br /><br /><em>edited by: jer029, Sep 10, 2018 - 04:29 PM</em><!-- end editby -->
Please Log in to join the conversation.
Time to create page: 0.062 seconds