A320Neo Bouncing on Runway

I've had a new problem appear recently. The plane will bounce back into the air as if it has hit an unseen bump on the runway. This is not due to a hard landing or control issue on take off. It has happened twice now for me - once when taking off and once when landing. Now I know it can bounce on a hard landing, but the landing I made yesterday was fine and the plane was rolling smoothly down the runway with med-auto braking and reverse thrust when it suddenly jumped high off the runway and crashed back down. This happened on a takeoff earlier where the plane was rolling on takeoff but not yet at VR. Suddenly again the plane leapt from the runway and came crashing back down again. I've read that others have had bouncing problems so I'm guessing this is yet another bug that affects at least some other users.

Since I'm using the A32NX mod addon, it could be related to that so I'm not sure at this point. I'll need to do some more flights with both default and the mod addon to see which one or if both have the issue. Too bad because it can wreck a good flight - especially an Econ-Mode flight here at SPA.

I had a similar issue this morning in the Cessna Citation Longitude. Trying to take off from Lincoln, Nebraska and the "bump" in the runway was so bad it actually caused the aircraft to crash. Said I had hit a stationary object but I was on takeoff roll. I guess slamming back down into the runway is hitting a stationary object...

I've tried 4 flights today and none of them worked correctly or ended in a crash. Every update pushed makes this simulator so much worse than it was before. Definitely feeling frustrated.

Ok...I think I discovered the problem. It had nothing to do with either flight mode. I believe it had to do with my setting graphic from "High" to "Ultra-High" setting. My system not able to keep up with it so the runway was still "adjusting" as I landed. There was actually visual fissures on the runway that hadn't fully "formed" as I rolled over it. As I sat on the runway I watched it finally smooth out. It doesn't take much of a "bump" to cause your plane to jump off the runway.

I reset graphics back to "High" and will see if that improves things in the future.

John

Last two flights with reduced settings appear to have corrected this issue. Checking MSFS forum I found others who had similar issues related to runway not fully forming before the plane tried to land on it.

While I can correct this by adjusting my settings, I would think that the developers might also make runway scenery a priority over other scenery loads that would prevent this from being an issue.